Fiber cement cladding is the first level of protection for your buildings envelope. The buildings skin if you will. This page discusses some of the special considerations dealing with the installation of fiber cement cladding.

Loads

Fiber cement panels can be heavy and this weight must be hung from the existing building structure by a system of steel subgirts and hatbars. These subgirts are tied into the buildings structure which might be existing structural steel, brick, wood or concrete.

To deal with dead load of the panels two or more fasteners in each panel are dedicated as "Fixed point dead load fasteners". These are carefully sized to ensure the weight is properly carried and are made so that there is no clearance to allow panel movement. The remaining fasteners on the panel are termed "active fasteners. These have hole clearance to allow building movement caused by wind loads and building creep as well as thermal expansion.

As well, specific subgirts can be specially designed to support the weight of extra large panels. Double fasteners may also be used at times when loads from snow and wind are particularily high. In highly insulated buildings, the thickness of the insulation can cause the subgirts to experience too much deflection requiring redesign. The spacing of subgirts is affected by the loads required and this in turn may change the location of fasteners.

Fasteners

Fastening methods for FC panels include screws and rivets. Rivets are generally favoured because they are inherently tamper proof and have mininmal impact on the look or aesthetic of the panel. Rivets used will typically be aluminum or stainless steel. A key requirement is the surface coating for the head of the rivet. Powder coated finishes matching the colour of the panel are preferred due to the ability of the powder coating to stand up to the weather.

Screws can also be used to secure panels and there are a number of tamper proof designs available. These typically involve special tools for installation and removal. Screws can also be purchased with decorative attachments to cover the heads. In this way the screw shape can be incorporated into the facades aesthetic.

Soffits made of fiber cement panels

Soffits made with fiber cement cladding also require special treatment for loads in the the dead load of the panel may cause "creep " or sagging. In soffits as well as the edges of wall cladding, the cantilever of the sub girts beneath must be restricted to make sure winds to pull off the edges of the panel.

Fiber cement installation tools and panels on eBay